Patch augmentation in patients with large to massive rotator cuff tear

Article information

Clin Shoulder Elb. 2023;26(1):1-2
Publication date (electronic) : 2023 February 16
doi : https://doi.org/10.5397/cise.2023.00094
Department of Orthopedic Surgery, Keimyung University Dongsan Hospital, Keimyung University School of Medicine, Daegu, Korea
Corresponding author: Du-Han Kim Department of Orthopedic Surgery, Keimyung University Dongsan Hospital, Keimyung University School of Medicine, 1035 Dalgubeol-daero, Dalseo-gu, Daegu 42601, Korea Tel: +82-53-258-4772, Fax: +82-53-258-4773, E-mail: osmdkdh@gmail.com
Received 2023 February 22; Revised 2023 February 7; Accepted 2023 February 8.

For rotator cuff tears greater than 3 cm, the re-tear rate was higher than 30% [1], while tears greater than 5 cm showed a re-tear rate higher 40% [1]. To overcome this problem and improve patient outcomes, several techniques have been introduced such as partial repair, biceps re-routing, balloon spacer insertion, and patch augmentation. Among them, recently, patch augmentation with rotator cuff repair has focused on the treatment of large to massive rotator cuff tear. After outcomes of patch augmentation were reported in the 2000s, there has been increasing interest in this technique to achieve successful rotator cuff repair [2]. The optimal aim of rotator cuff repair should be a healed tendon-bone interface, which can be achieved using one of several types of graft material. Xenograft (porcine small intestine or porcine dermal tissue) is no longer on the market because of sterile inflammatory reactions [2,3]. Synthetic grafts have been reported to have good outcomes because they have low re-tear rates and no tissue-related reactions. However, reports are limited, and available data are lacking to allow definitive conclusions. Due to advanced manufacturing and tissue engineering techniques, synthetic grafts are expected to recieve more interest [4]. Most recent publications have reported on the use of acellular dermal allograft. However, in countries where this is not available, autograft (fascia lata or quadriceps tendon) could be an option [5,6].

Patch augmentation is performed differently according to cuff integrity or repair situations. If a torn cuff tendon cannot be advanced to the tuberosity, the patch must span the gap between the tendon and the tuberosity as a bridge. If the tendon can be completely advanced to the native footprint, a patch graft is used as an onlay augmentation [2]. If the torn cuff is competely detached from the greater tuberosity, the patch could be placed between the glenoid and the tuberosity, known as “superior capsular reconstruction” and different from patch augmentation.

In a systematic review, augmentation did not show improved outcomes and healing rates compared with bridging [7]. However, pain score was significantly improved in the bridging group [7]. This result may be due to intraoperative situations and surgeon factors. Some surgeons may choose to complete repair using a mobilizing technique while others may choose partial repair with bridge augmentation. Also, a higher-tension repair could lead to pain or re-tear [8]. Therefore, proper cuff repair with or without augmentation (bridge or onlay) is a basic requirement and crucial to a successful outcome.

In terms of re-tear rate, patch augmentation in rotator cuff repair showed a lower rate than repair without patch augmentation, according to a recent meta-analysis study [9]. However, the effect on clinical outcomes was not clinically meaningful. To achieve promising outcomes, it is imperative to chose appropriate patients.

de Andrade et al. [9] found that the range of shoulder-forward flexion tended to be lower with patch augmentation. Choi et al. [10] reported that clinical outcomes and range of shoulder motion did not differ between the patch augmentation group and repair only group. However, others have reported that forward elevation was increased, suggesting that patch augmentation has not yielded promising results for shoulder range of motion [11,12]. Therefore, caution is needed in applying patch augmentation to cuff tear patients with pseudoparalysis.

Patch augmentation may be one of the preferred options for treating large to massive rotator cuff tears. However, when choosing a surgical option among various techniques, surgical success factors (re-tear rate or footprint coverage) and patient-based outcomes (minimum clinically important difference or substantial clinical benefit) must be considered. Further studies are necessary to better define the indications for patch augmentation using onlay or bridge technique.

Notes

Author contributions

Conceptualization: DHK. Supervision: CHC. Writing – original draft: DHK. Writing – review & editing: DHK, CHC.

Conflict of interest

Du-Han Kim is an editorial board member of the journal but was not involved in the peer reviewer selection, evaluation, or decision process of this article. No other potential conflicts of interest relevant to this article were reported.

Funding

None.

Data availability

None.

Acknowledgments

None.

References

1. Hein J, Reilly JM, Chae J, Maerz T, Anderson K. Retear rates after arthroscopic single-row, double-row, and suture bridge rotator cuff repair at a minimum of 1 year of imaging follow-up: a systematic review. Arthroscopy 2015;31:2274–81.
2. Chalmers PN, Tashjian RZ. Patch augmentation in rotator cuff repair. Curr Rev Musculoskelet Med 2020;13:561–71.
3. Cobb TE, Dimock RA, Memon SD, et al. Rotator cuff repair with patch augmentation: what do we know. Arch Bone Jt Surg 2022;10:833–46.
4. Karuppaiah K, Sinha J. Scaffolds in the management of massive rotator cuff tears: current concepts and literature review. EFORT Open Rev 2019;4:557–56.
5. Rosales-Varo AP, García-Espona MA, Roda-Murillo O. Outcomes of rotator cuff augmentation surgery with autologous fascia lata. Rev Esp Cir Ortop Traumatol (Engl Ed) 2018;62:157–67.
6. Tempelaere C, Desmoineaux P, Lespagnol F, Pierrart J, Beaufils P, Pujol N. Surgical repair of massive rotator cuff tendon tears: autologous quadriceps tendon graft versus arthroscopic repair. Orthop Traumatol Surg Res 2017;103:435–40.
7. Ono Y, Dávalos Herrera DA, Woodmass JM, Boorman RS, Thornton GM, Lo IK. Graft augmentation versus bridging for large to massive rotator cuff tears: a systematic review. Arthroscopy 2017;33:673–80.
8. Huberty DP, Schoolfield JD, Brady PC, Vadala AP, Arrigoni P, Burkhart SS. Incidence and treatment of postoperative stiffness following arthroscopic rotator cuff repair. Arthroscopy 2009;25:880–90.
9. de Andrade AL, Garcia TA, Brandão HS, Sardeli AV, Mouraria GG, Belangero WD. Benefits of patch augmentation on rotator cuff repair: a systematic review and meta-analysis. Orthop J Sports Med 2022;10:23259671211071146.
10. Choi S, Kim G, Lee Y, Kim BG, Jang I, Kim JH. Patch augmentation does not provide better clinical outcomes than arthroscopic rotator cuff repair for large to massive rotator cuff tears. Knee Surg Sports Traumatol Arthrosc 2022;30:3851–61.
11. Steinhaus ME, Makhni EC, Cole BJ, Romeo AA, Verma NN. Outcomes after patch use in rotator cuff repair. Arthroscopy 2016;32:1676–90.
12. Bailey JR, Kim C, Alentorn-Geli E, et al. Rotator cuff matrix augmentation and interposition: a systematic review and meta-analysis. Am J Sports Med 2019;47:1496–506.

Article information Continued